Well I think my issues are finally solved with my meth not spraying at high RPMs. Richard from Aquamist sent me a new controller in which he set up himself. And I went for a ride today. The meth no longer cuts off at higher RPMs. The gauge stayed lite up with 4-5 bars evenly all the way to redline instead of cutting off around 4500-5000. I also had a chance to do one log which in my opinion looks a ton better then any of the others. There were zero timing corrections. I was pretty concerned with corrections before but saw dzennos sticky on timing corrections which made me feel better. But as far as my log the IATs go from over 100 down to 75 at redline. Not once did they raise up in the 3rd gear pull. So not only can I see the meth is working from the flow gauge lighting up but the IATs are definately showing the meth is working. Ill attach the log. Hopefully everything else looks good. I did get another P3OFF boost leak at the end of the run.
↧