Clik here to view.
E60 535I LPFP upgrade help
Hi, I initially took out my LPFP to do an inline upgrade.. well that failed as the E60 is a bit different when it comes to the low pressure fuel pump. I decided on going with AEM 320 because a member...
View ArticleTrans upgrades
All over the forum i have seen that our trans is the ZF6HP21/19Z or TU. On real oem it says a weird GA6HP19Z. On wikipedia it says we indeed have a 6HP26. Im not sure which is more accurate but the 26...
View ArticleClik here to view.
Tonight's record run. 11.70 119 mph 335is w/JB4-BMS Flash, DP's DCI
Glad to report tonight's runs! Hot and Humid as usual here in Orlando, haven't adjusted for Density altitude. Here are a couple slips. I've been running map 6 peaking at 20 psi running around 12...
View ArticleBimmerBoost Flash and JB4 question
I have a couple questions if someone would mind answering them I would greatly appreciate it. So my car FBO, I just did the BimmerBoost Flash with one of Terry's race maps. 1) Is the JB4 just...
View ArticleSpecial thanks to Lulz_M3
Hey everyone. I have recently flashed my car with the BB flasher and just wanted to say thanks to everyone involved in making the BB flasher happen in the first place. Because I can't rep anyone yet I...
View ArticleClik here to view.
11.9 @ 119 VBOX vs. Drag Strip comparison 335XI
While track tuning a friendÂ’s 900whp civic last night at Island Dragway, I decided to make 2 runs with my 335XI 6AT. It wasnÂ’t the best day to run the car and knowing I wouldnÂ’t run my best time, I...
View ArticleRecommended inexpensive laptop for Bimmerboost flash
Unfortunately the only laptop that we have here is a mac and i need to find something to start playing around with this. Am i correct in understanding that windows 8 won't work for this? does anyone...
View ArticleInline LPFP Upgrade Setup Check-List
I know there's been a few threads on this on here and other forums, but I just wanted to confirm the setup and what's needed. I plan to have this done before I get proTUNED, so I wanted to make sure I...
View ArticleBMS 335I vs PTF 335is DCT
Much thanks to Terry@BMS for helping make this black 2009 e92 335i a beast! He has been relentless Day and Night with his support and his customer service CANNOT be matched by anyone else.... A battle...
View ArticleMany codes after dealer visit & installing a jb4.
Evening everyone! About 2 days ago i went to the dealer because my car was losing power when i pressed on the gas & the Service engine soon light will pop out & i the car will start shaking, i...
View ArticleClik here to view.
Some logs E85 mix-Meth and 20 PSI BimmerBoost Flash
So I finally got some E85, I am still working out problems with my meth system but so far this is how it looks. Map 7 with E85 Back end flash Attached Images  Â
View ArticleIs my LPFP dying?
Here's the log 1st gear into 2nd gear which slipped due to bald PSS rears. I see that Fuel LPFP PSI drops to 45 but LTFT Bank 1 stayed at 0%. Is anyone coming out with a PNP replacement solution?...
View Articleo2 Sensor Replacement
Recently started getting an SES/CEL on my dash, read the codes with my AP and it appears that my o2 Sensors (Pre & Post Cats) are dying. Naturally the STFTs & AFR are out of whack because it's...
View ArticleBlown motor!!? Not again??!
Last night I took my car out and noticed a knocking noise coming from the engine, I immediately pulled over and checked codes. There were none. Power is almost completely gone and car drives like a...
View ArticleCool! (Or too cool?) Oil temps with BMS thermostat delete?
Just installed BMS thermostat delete. During 20 minutes of easy low boost driving around town at 68F, oil temps maxed out at about 202F, getting only as high as 208F after climbing up a hill near me....
View ArticleWill reduced oil temps result in less oil vapor in the intake?
In another thread, I posted how I installed the BMS oil thermostat delete and saw an immediate 30F reduction in oil temps as a DD driving around town with little boost (I.e., no fun). So I'm wondering...
View ArticleClik here to view.
All ECU reads being equal, shouldn't the org files be identical?
Prior to having the OFT flash installed, I read the ECU with the BB flash 1.0.0.4 to serve as a backup being that I own a BT cable. I compared the two org files yesterday in TunerPro as I want to...
View ArticleTransmission Slipping issue ! SUCKS!
So after getting drag radials and flashing my car to the e85 map my transmission is now screwed I believe. The tranny jerks at times and after a couple of runs when upshifts happen there is a lag or...
View ArticleTunerPro questions
Is there a thread around here similar to this http://www.bimmerboost.com/showthrea...scussions-maps but for the tunerpro bimmerboost flash. I would like to play around with some stuff especially...
View ArticleInjector o-ring tools
Does anyone know the part numbers for the tools to put new o-rings on injectors? The numbers in the bentley manual are: 13 0 192, 13 0 193, 13 0 194, 13 0 195. They seem short for bmw part numbers. and...
View Article