DEFIV fab N54 diff lock down kit is now officially released!
Ok, Now that the first run are ready to ship first thing tomorrow, I figured I'd show you all the entire kit. The next run will be ready by next week, If your interested PM me. Other (M) variants...
View ArticleJust another n54 engine build thread
To make my long story short, younger brother ended up blowing my motor by throwing the trans into 2nd instead of 4th. As a result the timing chain had snapped and a few pistons seem to have kissed a...
View ArticleN54 Technical manual?
As in the title, i'm after one, some sort of manual that literally lists every part and location (even wiring diagram if possible), that sort of thing.. i can easily identify most of what i can see,...
View ArticleLog Check?
opinions? I cant graph them because the CSV grapher online does not work anymore. Attached Files datalog6(E50-meth) copy.txt (10.1 KB) datalog4(E50-meth) copy.txt (12.4 KB)
View ArticleER chargepipe with Aquamist bungs, Stripping?
Has anyone else had this problem of a ER charge-pipe actually stripping where the jet is inserted? This is the second chargepipe I have had this problem and its really frustrating.
View ArticleFirst time under the car (CDV Mod)
Let me preface this post by saying that I have zero experience with maintaining a car other than putting gas in it, getting the oil changed, and replacing wiper blades. I've been lurking here and...
View ArticleStage 3 update
Ok guys, so both Stage 3 manifolds are fully welded and mounted in the car. I am currently doing a rough plumb of all the oil and water lines, then I will move on to DP's then charge piping. I should...
View ArticleQuestion for procede owners (or people knowledgable with ECU wiring/piggy...
So, i'm uninstalling the procede from my harness, because i don't actually want it, it just happened to come with... so there's the red, blue, yellow, green wire harness things.. now, one of them has a...
View ArticleEngine Malfuction/ Limp mode (just installed DP's)
Hey guys i just had my AR design catless DP's installed on my 335xi and couple things going wrong. 1 is i always had a little rattle on my car thought it was the waste-gate rattle, never really...
View ArticleHelp, 335i differential C-clip secret sauce?
I cannot for the life of me get the first c-clip off the diff. I'm in the middle of a Wavetrac install. Has anyone had trouble with these c-clips? I've never had this kind of trouble before, even on...
View ArticleQuick and cheap fuel pump tool
This might not be specific to N54 as I've never seen the fuel pump setup on other newer BMWs. I searched and it seems like most people are able to get them off with a hammer and screwdriver or punch...
View ArticleDEFIV fab N54 diff lock down kit is now officially released!
Ok, Now that the first run are ready to ship first thing tomorrow, I figured I'd show you all the entire kit. The next run will be ready by next week, If your interested PM me. Other (M) variants...
View ArticleIf you could design your own ST kit for the N54...
What Turbo would you start with? Presion 6x66 series? -6466 is high on my list Borg Warner? -they make my head hurt but apparently are the jam beezy Other? FAQ/comments sure to come to which i wont...
View ArticleHave some old E-85...Safe to use or should I toss it..?
I have a couple 5 gallon jugs of E-85 in my garage...Been in there sealed (cool, dark place) for about 2-3 months... Needed to do some testing on some maps from Jake since I finally have some...
View ArticleManual Transmission Fluid
I see D4 and D6ATF are popular. What do people recommend? Do non-oem fluids make this box a little smoother?
View ArticleN54 Technical manual?
As in the title, i'm after one, some sort of manual that literally lists every part and location (even wiring diagram if possible), that sort of thing.. i can easily identify most of what i can see,...
View ArticleLog Check?
opinions? I cant graph them because the CSV grapher online does not work anymore. Attached Files datalog6(E50-meth) copy.txt (10.1 KB) datalog4(E50-meth) copy.txt (12.4 KB)
View ArticleER chargepipe with Aquamist bungs, Stripping?
Has anyone else had this problem of a ER charge-pipe actually stripping where the jet is inserted? This is the second chargepipe I have had this problem and its really frustrating.
View ArticleFirst time under the car (CDV Mod)
Let me preface this post by saying that I have zero experience with maintaining a car other than putting gas in it, getting the oil changed, and replacing wiper blades. I've been lurking here and...
View Article